Safety instructions
16
IRDH575_D00089_05_M_XXEN/01.2020
2.4 Use for the intended purpose
The ISOMETER® is exclusively intended for:
monitoring the insulation resistance of IT systems and
localization of insulation faults in combination with insulation fault
evaluators EDS4…
In order to meet the requirements of the applicable standards, customised pa-
rameter settings must be made on the equipment in order to adapt it to local
equipment and operating conditions. Please heed the limits of the range of
application indicated in the technical data.
Any use other than that described in this manual is regarded as improper.
To Next Page
Loading...
Need help?
General
