Bender ISOMETER IRDH575 - Factory Settings

Factory settings
90
IRDH575_D00089_05_M_XXEN/01.2020
Please check if the basic setting of the ISOMETER® complies with the require-
ments of the system to be monitored.
6. EDS.460/490 1. Exit
Depends on setting
EDS460/490
2. General
3. Channel:
4. Relay:
5. Test/Reset
7. EDS470 1. Exit
Depends on setting
EDS460/490
2. EDS Monitor
3. EDS Test:
4. EDS Reset:
5. Relay:
6. Memory:
7. CT Setup:
8. n-peak:
8. COM SETUP 1. Exit
2. Addr: 1=Master
3. ISOnet: off
4. ISO Monitor:
9. PASSWORD 1. Exit
2. Password: 000
3. Status: off
10. LANGUAGE 1. Exit
2. Text: German
9. SERVICE (Access only for Bender service personnel)
Menu Submenu Setting