PL-6000DC/DCX Two-Post Parking Lift 15 P/N 5900273 — Rev. A6 —July 2024
Installation
The installation process includes multiple steps. Perform them in the order listed.
⚠ WARNING Only use the factory-supplied parts that came with your Lift. If you use
parts from a different source, you void your Warranty and compromise the safety of everyone who
installs or uses the Lift. If you are missing parts, visit bendpak.com/support or call
(800) 253-2363, follow the prompts to reach support.
Safety
While installing this equipment, your safety depends on proper training and thoughtful operation.
⚠ WARNING Do not install this equipment unless you have automotive Lift installation training.
Always use proper lifting tools, such as a Forklift or Shop Crane, to lift heavy
components. Do not install this equipment without reading and understanding this
Manual and the Labels on the unit.
Only fully trained personnel should be involved in installing this equipment. Always pay attention. Use
appropriate tools and lifting equipment. Stay clear of moving parts.
⚠ WARNING You must always wear OSHA-approved (publication 3151) appropriate protective
equipment during installation: leather gloves, steel-toed work boots, eye protection,
back belts, and hearing protection are mandatory.
Tools Required
You may need some or all of the following tools:
Rotary hammer drill (or similar)
12 mm carbide bit (conforming to ANSI
B212.15)
Hammer and crowbar
Four-foot level
Open-end wrench set, metric
Socket and ratchet set, metric
Hex key wrench set, metric
Medium crescent wrench
Torque wrench
• Phillips and slotted screwdrivers
• Hammer
• Chalk line
• Medium-sized flat screwdriver
• Tape measure, 25 feet or above
• Needle-nose pliers
• Forklift, or Shop Crane 2 Ton capacity
• White Lithium Grease
• Machine oil for Chain lubrication
• Thread Sealant
To Next Page
Loading...
