PL-6000DC/DCX Two-Post Parking Lift 41 P/N 5900273 — Rev. A6 —July 2024
Install the Power Unit
This section describes the mounting of the Hydraulic Power Unit. An Electrician is not required to
mount the Power Unit to the Powerside Post.
⚠ DANGER Risk of explosion: This equipment has internal arcing or parts that may spark and
should not be exposed to flammable vapors. Never expose the Motor to rain or
other damp environments.
⚠ WARNING Running the Power Unit without Hydraulic Fluid will damage it and this damage is
not covered under warranty.
⚠ WARNING Damage to the Power unit due to water, detergents, acid, and other liquids is not
covered under warranty.
⚠ WARNING The Power Unit is very heavy. BendPak strongly recommends you mount the
Power unit with the reservoir empty. One person should support the Power unit in
place while another bolts the unit into place.
To install the Power Unit:
1. Retrieve the Power Unit Mount. Two possible mounts may be shipped with the Lift. One connects
to the power unit block, the other connects at the motor mount. Retrieve the Bolts and Flat
Washers to mount the Power Unit and mount to the Lift Post as shown.
To Next Page
Loading...
