PL-6000DC/DCX Two-Post Parking Lift 61 P/N 5900273 — Rev. A6 —July 2024
Maintenance
Proper and regular maintenance will extend the life of your Lift and reduce downtime due to
component failures.
⚠ DANGER Before performing any maintenance on your Lift, make sure it is completely
disconnected from power. Do not reconnect it until all maintenance procedures are
finished. The Lift uses electrical energy; if your organization has Lockout/Tagout
policies, make sure to implement them before performing any maintenance. If you
come into contact with high voltage/current, you could be injured or killed.
⚠ DANGER Verify the Lift is resting on a Safety Lock or on the ground before performing any
maintenance. Do not work on the Lift if the Safety Locks are not engaged, you
could be injured or killed.
If you need to replace worn, damaged, or broken parts, you must use parts from (or approved by) the
original equipment manufacturer (OEM) or parts that meet the OEM’s specifications.
⚠ WARNING If you use parts not from, approved by, or meeting the specifications of the original
equipment manufacturer, you void your warranty and compromise the safety of
everyone who installs or uses the Lift.
To maintain your Lift:
• Daily: Keep the Lift clean. Wipe up any spills and remove dirt.
• Daily: Make a visual inspection of all moving parts and check for damage or excessive wear.
Replace any damaged or worn parts before using the Lift.
⚠ DANGER Do not use the Lift if the Lifting or Balancing Chains are damaged or extremely
worn. If a Vehicle is raised when you notice the damage or wear, very carefully
lower the Vehicle to the ground, if this can be done safely; if it cannot be done
safely, evacuate the area and make arrangements with trained lift service personnel
to lower the Vehicle. When the Lift is on the ground, take it out of service,
disconnect it from power, and make arrangements with trained lift service
personnel to fix the damage and/or wear.
• Daily: Determine the cause of any abnormal noise.
• Daily: Verify all safety devices are operating and in good condition.
⚠ WARNING Do not use a Platform if its Safety Lock is damaged or excessively worn.
• Weekly: Check all Controls, including Emergency Stop, to make sure they are functioning.
• Weekly: Check all Labels on the Lift. Replace them if they are illegible or missing.
• Monthly: Grease the lubrication points on the Lift. Use white lithium grease or similar.
• Monthly: Check Hydraulic Fluid levels in the reservoir when the Platform is at its lowest position.
Refill as required.
• Monthly: Check the inlet filter inside the Hydraulic Oil Reservoir. Clean or replace the Filter as
required.
• Monthly: Check Hydraulic Hoses for cracks, abrasion, or leaks. Replace as required.
• Monthly: Check power supply wiring, if possible. Replace any wiring with cracked or damaged
insulation.
To Next Page
Loading...
