PL-6000DC/DCX Two-Post Parking Lift 4 P/N 5900273 — Rev. A6 —July 2024
Table of Contents
Introduction 4 Operation 57
Shipping Information 5 Maintenance 61
Safety Considerations 5 Troubleshooting 65
Components 8 Multiple Lift Installations 69
FAQs 9 Wiring Diagram 73
Specifications 10 Labels 79
Will My Car Fit? 11 Parts Drawings 82
Orientation 13 American Lift Institute (ALI) 93
Installation Checklist 14 Maintenance Log 94
Installation 15
Introduction
This Manual describes the PL-6000DC and PL-6000DCX Two-Post Parking Lifts designed to
accommodate most cars and light trucks. The platform supports up to 6,000 lbs. (2,722 kg) and is
designed for indoor locations only.
PL-6000DC –
Supports up to 6,000 lbs. (2,722 kg) with a usable platform width of 82.5 in. (2,100 mm).
PL-6000DCX - Supports up to 6,000 lbs. (2,722 kg) with a usable platform width of 94.5 in. (2,400 mm).
The PL-6000DC/DCX can accommodate multiple side-by-side installations by sharing a Lift Post
between lifts. Each Lift requires a dedicated Power Unit. See the Multiple Lift Installations
section for more information. More information about the full line of BendPak products can be found at
bendpak.com.
This Manual is mandatory reading for all users of PL-6000DC/DCX Lifts, including
anyone who installs, uses, maintains, or repairs them.
⚠ DANGER Be extremely careful when installing, operating, maintaining, or repairing this
equipment; failure to do so could result in property damage, product damage,
injury, or (in very rare cases) death. Make sure only authorized personnel operate
this equipment. All repairs must be performed by an authorized technician. Do not
make modifications to the unit; this voids the warranty and increases the chances
of injury or property damage. Make sure to read and follow the instructions on the
labels on the unit.
Keep this Manual on or near the equipment so that anyone who uses or services it can read it. If you are having
issues, refer to the Troubleshooting section of this Manual for assistance.
Technical support and service is available from your dealer, on the Web at bendpak.com/support, by email
at support@bendpak.com, or by phone at (800) 253-2363 follow the prompts to reach support or sales.
To Next Page
Loading...
