EasyManua.ls Logo

BendPak PL-6000DC - Page 39

BendPak PL-6000DC
96 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PL-6000DC/DCX Two-Post Parking Lift 39 P/N 5900273Rev. A6 —July 2024
Hydraulic System Warnings
Before applying power to the Hydraulic System note the following Warnings:
WARNING Failure to observe these warnings can result in serious personal injury including, in
rare cases, death.
WARNING The Hydraulic hoses and connections must be inspected before any attempt to
raise a Vehicle is made.
WARNING Verify all Hydraulic Hose connections and fittings, including unused auxiliary port
plugs on the Power Unit, the Flow Divider, the Cylinders and anywhere else in the
Hydraulic System are tightened.
WARNING The Power Unit is a Hydraulic Pump capable of developing pressures in excess of
5,000 psi (345 BAR). A pressure relief valve is used to set the pressure at the
desired level. Tampering with, adjusting, modifying, or removing the relief valve is
extremely dangerous and is not recommended. Only trained Hydraulics technicians
should make adjustments to the relief valve, using calibrated hydraulic pressure
gauges to assure the proper pressure setting is achieved.
WARNING Changes to the output pressure may render the power unit incompatible with
pressure limitations of other components in the hydraulic circuit. This may cause
catastrophic failure of those components, and could result in property damage,
serious personal injury, or death.
WARNING The Hydraulic System can contain high pressure which, if suddenly released, can
cause serious injury or death.
WARNING Do not attempt to connect or disconnect Hydraulic Hoses while the equipment is
loaded or while a Vehicle is on the Lift or the Hydraulic System is under pressure.
WARNING Keep bare hands away from Hydraulic Fluid; always wear gloves when handling
Hydraulic Fluid, Cylinders or Hydraulic Hoses.
WARNING When handling Hydraulic Fluid, always observe the safety instructions from the
manufacturer.
WARNING Always promptly clean any Hydraulic Fluid spills. If a leak is the source of the spill,
lockout the Lift to prevent use until the Hydraulic System is repaired.

Related product manuals