OSD (On-Screen Display) menu 39
English
3. Press to highlight Frequency and then press + or - to start the tuning
system. The tuning result will display on-screen in real-time. If the tuned
program is incorrect, press
+ or - again until your desired program is
located. You can directly input the frequency using the Program selection
numeric buttons on the remote control if you wish.
4. Press to highlight
Fine Tune and then press + or - to adjust the
reception of TV signal (only necessary where the image or sound reception
is poor).
5. Press to highlight
Text Code and then press + or - to select a code
format for the Teletext function according to the table below:
6. Press to highlight
Store on PROG., and then press the Program
selection numeric buttons on the remote control to enter the number
(location) for this program. Press
OK to confirm.
7. Press
MENU to save the program and close the menu.
Editing programs
After the TV programs are scanned and stored in the TV’s memory during the
First Turn On operation (see "9. Initialize your TV" on page 8) or after using
the Auto Installation function, you can edit these programs by deleting
unwanted programs, adding a program name or changing the program
position number.
This option is not possible when the Child Lock is activated. See "Child Lock" on
page 42.
Text code Language
Char.1 West European languages
Char.2 East European languages
Char.3 Turkish/Greek
Char.4 Cyrillic languages
Char.5 Arabic languages
Char.6 Farsi languages
V32B_V37B_EN.book Page 39 Wednesday, January 23, 2008 10:55 AM
To Next Page
Loading...
