BENSHAW RSi GX Series - Page 46

•
Frequency Setting
When changing run frequency to 30.05 Hz in Drive group.
•
Changing parameter value in Function group
When changing the parameter value of F28 from 2 to 5.
40
4 - Operation
1
In “0.00”, press the Ent () key once.
2
The second decimal 0 becomes active.
Press the UP (p) key until 5 is displayed.
3
Press the Left (t) key once.
4
The first decimal 0 becomes active.
Press the Left (t) key once.
5
Press the Left (t) key once.
6
Set 3 using UP (p) key.
7
Press the Ent () key.
30.05 is blinking.
Press the Ent () key.
8
30.05 is entered into memory.
z Note: The RSi-GX display can be extended to 5 digits using left (t)/right (u) keys.
z Note: The parameter setting is disabled when pressing other than Enter Key in step 7.
0.00
30.05
1
In F0, press the Ent () key once.
2
Check the present code number.
Increase the value to 8 by pressing the Up (p) key.
3
When 8 is set, press the Left (t) key once.
4
0 in 08 is active.
Increase the value to 2 by pressing the Up (p) key.
5
28 is displayed
Press the Ent () key once.
6
The parameter number F28 is displayed.
Press the Ent () key once to check the set value.
7
The preset value 2 is displayed.
Increase the value to 5 using UP key (p).
8
Press the Ent () key.
9
Code number will appear after 5 is blinking. Parameter change is
complete. Press either Left (t) or Right (u) keys.
10
Moving to first code of Function group 1 is complete.
z Note: The above setting is also applied to change parameter values in function group 2 and I/O
group.
F0
1
8
F28
2
5
F28
F0
0.00
0.05
0.05
0.05
00.05
30.05
08
28