15
Attaching and Removing the Presser Foot
Holder
• Removing Presser foot holder
Remove the setscrew by turning it counterclockwise with
a screwdriver.
• Attaching Presser foot holder
Match the hole in the presser foot holder with the
threaded hole in the presser bar.
Fit the setscrew into the hole.
Tighten the setscrew by turning it clockwise with the
screwdriver.
Setscrew
Presser foot holder
Hole
Threaded hole
CAUTION:
Turn OFF the power switch before removing or attaching
the presser foot holder.
Changing the Presser Foot
• Removing the presser foot
Raise the needle to its highest position by turning the hand-
wheel counterclockwise. Raise the presser foot, and press the
lever on the back of the presser foot holder.
Lever
• Attaching the presser foot
Place the desired presser foot, so that the pin on the foot lies
just under the notch on the presser foot holder.
Lower the presser foot lever to lock the foot in place.
Notch
Pin
CAUTION:
Turn OFF the power switch before changing the foot.
Always use the proper foot for the selected pattern.
The wrong foot can cause the needle to break. Each foot
is marked with an identification letter.
Identification letter
To Next Page
Loading...
