Bernette b77 - Page 12

My bernette
12
2022-08 EN 5020077.40A.04
Operating Components
Number Operating
Component
Name Purpose
1 Quick Reverse > To sew backward, press the «Quick
Reverse» button.
> To sew backward permanently, keep the
«Quick Reverse» button pressed.
The «Quick Reverse» button does not work
for stitch patterns 22–24 and for buttonhole
patterns 51–71.
2 Thread Cutter > To cut the upper thread and the lower
thread automatically, press the «Thread
Cutter» button.
2-6 securing stitches can be programmed in
the Setup-Program. They are sewn before the
thread is cut.
3 Presser Foot Up/
Down
> Press the «Presser Foot Up/Down» button
to raise the presser foot into a hovering
position.
> Press the button «Presser Foot Up/Down »
to raise the presser foot.
4 Start/Stop The button «Start/Stop» is used to change
the presser foot position and to start the
machine.
> To start the machine, keep the button
«Start/Stop» pressed for 2 seconds.
> Press the button «Presser Foot Up/Down»
briefly to raise the presser foot into
hovering position.
5 Needle Up/Down > Push the button «Needle Up/Down» to
lower the needle.
> Push the «Needle Up/Down» button
again to raise the needle.