109
BSR
Preparation
► use Slide-on table
► attach the desired presser foot sole to the BSR Presser
Foot
‣ removing sole: press both buttons (see arrows) on
each side of the foot
‣ slide the sole down the groove at an angle
‣ attaching the sole: slide the sole up in the groove
until it clicks into place
► attach the BSR Presser Foot to the sewing computer
and plug the cable in the outlet provided
► the «BSR» screen opens automatically
► the BSR mode 1 is activated (BSR1 is standard)
► the basic stitch length setting is 2mm
► set the desired stitch length
► when sewing small forms and stippling, stitch length of
1mm - 1.5mm is suggested
Presser Foot Pressure may be reduced
depending on the fabric type and thickness.
To Next Page
Loading...
