EasyManua.ls Logo

Bernina 820 - Screen Calibration Procedure

Bernina 820
148 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
42
Screen Calibration
► touch the calibration icon
► another screen appears
► with touch pen touch the center of the cross. The cross
moves to the next position
► repeat this until all three positions shown are calibrated
► touch
to save settings
The calibration screen can also be opened
this way:
► switch sewing computer off (to «0»)
► touch the two needle positioning buttons
on the front panel and keep them pressed
► switch sewing computer on (to «I») and as
soon as the calibration screen is opened,
release the two buttons
Setup Program
032298.53.04_1204_B820_EN

Table of Contents