22
Preparation
Changing the Needle
► raise the needle
► lower the presser foot and turn the power switch to «0»
Removing the Needle
► loosen the clamp screw with the gray screwdriver and
pull needle down
Inserting the Needle
► flat side of needle to the back
► insert the needle with the mulitfunction tool as far as it
will go
► tighten needle clamp screw
Changing the Presser Foot
► raise the needle and presser foot
► turn power switch to «0» (off)
Releasing the Presser Foot
► raise the clamping lever
► remove presser foot
Attaching the Presser Foot
► guide the presser foot upwards over the cone
► touch the clamping lever down
Turn the handwheel to lower the needle in
order to get better access to the fastening
screw.
To Next Page
