Berthold LB 444 - Setup Protocol

Density Meter LB 444 SECTION 10. APPENDIX
97
10.6 Setup Protocol
Measuring Point ............................................ Date ............................
Radioactive source: No. .......................... Activity .......................... Isotope ..................
Pipeline .................................... mm Material ...................................
Irradiation angle: 90°/45°/30°/others ..................
Product .........................................................................
Parameters Range value
Password
Instrument ID
Program Version
Instrument configuration
Radiation Yes/No
Error mode Halt/Continue
Product no. 1/2/3/4
Measuring path Cm
Measure mode
Time constant S
Rapid switch-over On/Off
Σ for Interference Radiation
0-10
Countrate threshold (min)
I*·s
-1
Countrate threshold (max)
I*·s
-1
Current input for temperature: 0-20mA or 4-20mA
0/4 mA °C
20 mA °C
Current out for density or conc. 0-20mA or 4-20mA
0/4 mA
20 mA
Current output error Hold value: 0-22mA
Relay 2 Setup Min or Max:
Hysteresis 0-10%
Relay 3 Setup Min or Max:
Hysteresis 0-10%
Solids density:
Liquid density:
Water TC Yes/No
TC1
TC2
Reference temperature