Density Meter LB 444 SECTION 1. INTRODUCTION
1
1. INTRODUCTION
1.1 Safety Summary
Electrical Shock Hazard
Disconnect power during installation and before servicing.
Never change the installation or the parameter settings without a
full knowledge of the relevant part of this manual, the connected
controller and the process controlled by this measuring device.
This measuring device utilizes radioactive sources. Strict compli-
ance to the rules of Radiation Protection and regulations governing
the use of radioactive sources is mandatory.
Installation, dismantling, relocation, maintenance or testing involv-
ing the radioactive source or its shielding, may ONLY be performed
by persons specifically licensed by the US Nuclear Regulatory
Commission or an Agreement State.
GENERAL WARNINGS
SPECIFIC WARNINGS
SPECIFIC CAUTIONS
To Next Page
Loading...
