EasyManua.ls Logo

Beta ALP 200 - Engine Shut-Down; Startup

Beta ALP 200
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
OPERATION
32
EN
STARTUP
Set the fuel tank tap to ON or RES
(see page 18).
- Position the key to
(see page 21).
- Make sure the right switch on the handlebar is on
(page 19)
- Check that the gears are in neutral (page 20).
- Pull the clutch lever (page 18).
WARNING!
If you do not pull the clutch lever the vehicle will not start.
- Retract the stand (page 20).
WARNING!
If the stand is not retracted, the engine will stall when the gears are engaged.
ELECTRIC START
(page 19):
Push the button until the engine starts. Do not press the button while the engine is
running.
KICKSTART (page 20):
Depress the kick-starter with a sharp movement of the foot.
ATTENTION!
Once the pedal has been depressed, release it immediately. This avoids jolts to the
entire ignition group and to the foot.
COLD STARTING:
Turn on the starter (page 19), when the engine is cold, start the vehicle, wait a
few minutes, then move the starter back to its starting position.
ENGINE SHUT-DOWN
To shut-down the engine, proceed in one of the two following ways:
- turn the key to
(see
page 21
).
- press the button on the switch unit (see page 19).
NOTE:
With the engine stopped, always set the fuel tap to OFF (page 18).

Table of Contents

Other manuals for Beta ALP 200

Related product manuals