Beta ALP 200 - Common Problems and Solutions

6
TROUBLESHOOTING
66
EN
TROUBLESHOOTING
PROBLEM CAUSE REMEDY
The engine starts but the
telltale “MIL” lights on
Engine management system fault Contact authorised BETAMOTOR customer
service
The electric starter does
not turn
Key in position
Move the key on
Flat battery Check the battery
Blown fuse Replace
Defective relay Contact authorised BETAMOTOR customer
service
Defective starter motor Contact authorised BETAMOTOR customer
service
The engine turns over but will
not start
Fuel cock in OFF position Move the fuel cock to ON or RES position
Dirty carburettor jets Contact authorised BETAMOTOR customer
service
Spark plug oily or wet Clean and dry the spark plug, replace if
necessary
Spark gap wrongly adjusted Restore the spark gap
Fault in the ignition system Contact authorised BETAMOTOR customer
service
The power delivered by the
engine is insufficient
Tank vent obstructed Check the tank vent
Fuel system dirty Contact authorised BETAMOTOR customer
service
Air filter dirty Clean air filter
Defective ignition system Contact authorised BETAMOTOR customer
service
The motor stops or splutters Lack of fuel Move the fuel cock to RES
Refuel
Poor carburettor seal Make sure that the hose between carbure-
tor and engine is intact
Loose or oxidized connector or ignition
coil
Check the connector. Clean and treat with
specific spray
Engine overheats
Insufficient air flow Stop the engine when vehicle is stationary
Silencer partly clogged Contact authorised BETAMOTOR customer
service
Carburation too lean Contact authorised BETAMOTOR customer
service
Front braking poor Brake pads worn Contact authorised BETAMOTOR customer
service
Air or humidity in the hydraulic circuit Contact authorised BETAMOTOR customer
service
Rear braking poor Brake pads worn Contact authorised BETAMOTOR customer
service
Air or humidity in the hydraulic circuit Contact authorised BETAMOTOR customer
service