Beta ALP 200 - Brake Adjustments and Wear Checks; Clutch and Throttle Adjustments

ADJUSTMENTS
34
EN
3
KEY TO SYMBOLS
Tightening torque
BRAKES
FRONT BRAKE
The front brake is disk type with hydraulic
control.
Use the adjusting nut 1 to vary the inter-
vention point.
WARNING: reduced play causes brake
overheating leading to sudden lockup.
REAR BRAKE
The home position of brake pedal can be
altered by turning adjusting screw 1.
Adjust by loosening locknut 2 and adjust-
ing screw 1.
Retighten the locknuts 2 after completing
the operation.
ADJUSTMENT OF CLUTCH
LEVER
To perform the adjustment, lift rubber dust
cover 1 and turn adjuster 2.
The lever must have 5 mm of idle stroke.
1
2
1
2
1