Beta ALP 200 - Bleeding the Front Brake; Front Brake Lining Control

4
CHECKS AND MAINTENANCE
44
EN
BLEEDING THE FRONT BRAKE
To bleed air from the front brake circuit,
proceed as follows:
•Removetherubbercap1 from the valve
2.
•Openthesumpcap.
•Insertoneendofatransparenttubeinto
a container.
•Pumpwiththebrakelever2/3timesand
keep the lever pressed.
•Unscrewthevalveandlettheoildrain.
•Ifarestillvisibleinthetuberepeatabove
operation until obtaining a continuous
outflow of oil within no air bubbles.
•Closethevalveandreleasethelever.
NOTE:
During this procedure, continuously top up
the brake pump thank to replace the oil that
is out flowing.
•Removethetube.
•Replacetherubbercap.
Close the oil reservoir cap.
FRONT BRAKE LINING CONTROL
In order to verify the wear condition of front
brake is enough to view the caliper from
the bottom, where is possible to glimpse
the brake lining tails which will have to
show a brake of 2 mm in thickness. If the
stratum is lesser let’s start replacing them.
NOTE:
Perform the check according to the times
shown in the table on page 59.
To replace, contact authorised Betamotor
customer service.
2 mm
1
2