Beta ALP 200 - Plate Light; Tail Light; Turn Indicators

4
CHECKS AND MAINTENANCE
53
EN
A
TURN INDICATORS
To reach the bulb, remove the glass cover
by loosening screw A.
Remove the bulb from the connectors and
carry out replacement.
TAIL LIGHT
Keep the headlight glass clean at all times
(see page 57).
The LED tail light is sealed. In the case of
burnout of one or more LEDs it is necessary
to replace the entire group.
To replace, contact authorised Betamotor
customer service.
PLATE LIGHT
To replace the plate light:
- remove screw 1;
- remove the unit from the mudguard;
- Remove the entire lamp holder 2 from the
license plate light;
- Remove the bulb from the lamp holder.
- Replace with a new lamp (page 16
for lamp info).
To refit, follow the procedure above but in
reverse order.
1
2