Beta ALP 200 - Bleeding the Rear Brake; Rear Brake Lining Control

4
CHECKS AND MAINTENANCE
46
EN
BLEEDING THE REAR BRAKE
To bleed air from the rear brake circuit,
proceed as follows:
•Removetherubbercap1 from the valve
2.
•Openthesumpcap.
•Insertoneendofatransparenttubeinto
a container.
•Pumpwiththebrakelever2/3timesand
keep the lever pressed.
•Unscrewthevalveandlettheoildrain.
• If are still visible in the tube repeat above
operation until obtaining a continuous
outflow of oil within no air bubbles.
• Close the valve and release the lever.
NOTE:
During this procedure, continuously top up
the brake pump thank to replace the oil that
is out flowing.
•Removethetube.
•Replacetherubbercap.
Close the oil reservoir cap.
1
2
2 mm
REAR BRAKE LINING CONTROL
In order to verify the wear condition of rear
brake is enough to view the caliper from
the back side, where is possible to glimpse
the brake lining tails which will have to
show a brake of 2 mm in thickness. If the
stratum is lesser let’s start replacing them.
NOTE:
Perform the check according to the times
shown in the table on page 59.
To replace, contact authorised Betamotor
customer service.