BIFFI F01-2000 Instructions And Operating Manual

37
BIFFI F01-2000 ELECTRIC ACTUATOR
INSTRUCTION AND OPERATING MANUAL
Last maintenance date
• Press YES if the date is correct, press NO to
change it.
• Enter day, month, and year. Press NO to
scroll the list of available values, press YES
to select.
• Press YES if the date is correct.
Next maintenance date
• Press YES if the date is correct, press NO to
change it.
• Enter day, month, and year. Press NO to
scroll the list of available values, press YES
to select.
• Press YES if the date is correct.
Configuration procedure
• Move the local selector to OFF and then
simultaneously press OPEN and STOP.
Select the language and enter the password
according to the instructions (see “Entering
the set-up mode”). When the message
displayed is “SET-UP MODE OK?” press YES.
Press NO to scroll the list of available menus
and then YES to select the maintenance
menu.
• Press NO to scroll the list of available
routines and press YES to select maintenance
date.
• Press YES to set the last maintenance date.
Press NO to skip to “next maintenance date”.
9�3�6 Set maintenance date
The maintenance date routine allows the
following operations:
- to set the last maintenance date
- to set the next maintenance date
- to set the start-up date
Start-up date
• Press YES if the date is correct, press NO to
change it.
• Enter day, month, and year. Press NO to
scroll the list of available values, press YES
to select.
• Press YES if the date is correct.
Logger mode recorder, event, off
Sampling time from 1 to 3600 secs (the sampling time is only used in recorder mode)
Memory mode stop when memory is full, continuous (stop after overwriting the memory 5000 times (event)
and 10000 times (recorder/T-recorder)
Start date date when the logger starts
Start time time when the logger starts
9�3�7 Set data logger
The “data logger” routine allows to set the
data logger parameters (see VIEW mode,
Maintenance, Data logger, paragraph 10.4.6).
To start the data logger the following data
should be set:
Configuration procedure
• Move the local selector to OFF and then
simultaneously press OPEN and STOP. Select
the language and then enter the password
according to the instructions (see “Entering
the set-up mode”). When the message
displayed is “SET-UP MODE OK?” press YES.
Press NO to scroll the list of available menus
and then press YES to select maintenance
menu.
• Press NO to scroll the list of available
routines and then press YES to select
“data logger”.
• Press YES if the mode is correct. Press NO
to scroll the list of modes and press YES to
select the desired value .
• Press YES if the sampling time is correct.
Press NO to scroll the list of times and press
YES to select the desired value.
• Press YES if the memory mode is correct
(stop when full or continuous). Press NO to
change and press YES to select.
• Press YES if the start time is correct. Press
NO to scroll the list and press YES to select
the desired sampling times (hour, min, sec).
• Press YES if the start date is correct. Press
NO to scroll the list and press YES to select
the desired sampling times (day, month,
year).
• Press YES to confirm the above settings.

BIFFI F01-2000 Specifications

General

Brand	BIFFI
Model	F01-2000
Category	Controller
Language	English