September 2021
Installation, Operation and Maintenance Manual
VCIOM-01249-EN Rev. 0
41Local Controls
Section 6: Local Controls
Description of Variables and Reports
torque output torque in % of the nominal torque stated in the
NAMEPLATE menu
motor speed RPM of electrical motor
main voltage voltage (V) and frequency (Hz) of mains
current current (A) absorbed by the motor
temperature temperature (°C), inside the electronic compartment
time present time
date present date
alarm list of present alarms (see Section 12.10, Diagnostic messages)
warning list of present warnings (see Section 12.10, Diagnostic messages)
Ktemp temperature factor
mot temp temperature (°C) of the electrical motor
term temp temperature (°C) inside the terminal board compartment
log status data logger status (off, ready, in progress: E: event number - n° of
memory cycle or R: sample number - n° of memory cycle)
wireless report Bluetooth™ interface status (ready, not ready)
node report report of bus interface card (only present if the bus card is present)
(see the relevant instruction manual)
FDI report report of FDI function (only present if the LonWorks bus card is
present) (see the relevant instruction manual)
base report base card report
- card code
- manufacturing week and year
- electrical diagram, etc.
term report terminal board card report
- card code
- manufacturing week and year
- electrical diagram, etc.
Ain/Aout report Ain/Aout card report (only present if the card is present)
- card code
- manufacturing week and year
- electrical diagram, etc.
The warning condition occurs when a variable reaches a critical value and/or a maintenance
action is required, but the actuator control functions are still available. The alarm condition
occurs when a variable is out of the acceptable range and the actuator control functions
are not available.
The alarm and warning lists only contain the present alarms and warnings. When the fault
condition disappears, the corresponding alarm or warning disappears from the list. A reset
routine is provided to clear the type of alarm/warning that are memorized (over-torque,
jammed valve, etc.).
To Next Page
Loading...
Need help?
General
