BIFFI F01-2000 User Manual

September 2021
Installation, Operation and Maintenance Manual
VCIOM-01249-EN Rev. 0
74
Set-Up Routines
Section 9: Set-Up Routines
9.3.1 Set Password
The actuator is supplied by Bif with a default password (“0 0 0 0”). By the above routine,
the end user can enter a different password consisting of 4 alphanumeric characters.
After entering the new password, the old one ceases to be valid. Therefore, it is mandatory
“NOT TO FORGET THE PASSWORD” after the default one has been modied. Forgetting the
new password makes it impossible to enter the set-up menu and to congure the actuator.
Conguration procedure
• Move the local selector to OFF and then simultaneously press OPEN and STOP.
Select the language and enter the password according to the instructions
(see “Entering the set-up mode”). When the message displayed is “SET-UP MODE
OK?” press YES. Press NO to scroll the list of available menus and then press YES to
select Maintenance menu.
• Press NO to scroll the list of available routines and then press YES to select Set
password. Press YES again to select Enter new password.
• Enter the new password one digit at a time. Press YES if the digit is correct, press
NO to scroll the list of available characters and then press YES to select. Enter 4
digits. When the display shows the message, Password changed the old password
is no longer valid.
9.3.2 Clear Alarm Log
Clear Procedure
• Move the local selector to OFF and then simultaneously press OPEN and STOP.
Select the language and enter the password according to the instructions (see
“Entering the set-up mode”). When the message displayed is “SET-UP MODE OK?”
press YES. Press NO to scroll the list of available menus and then press YES to select
the Maintenance menu.
• Press NO to scroll the list of available routines and then press YES to select clear
alarm log.
• Press YES to clear alarm log.
9.3.3 Set Torque Reference
The set torque prole reference routine allows to transfer the last torque prole to the
reference prole registers. The old reference data are lost, and the new ones are used as a
new reference torque prole.
• Move the local selector to OFF and then simultaneously press OPEN and STOP.
Select the language and enter the password according to the instructions
(see “Entering the set-up mode”). When the message displayed is “SET-UP MODE
OK?” press YES. Press NO to scroll the list of available menus and then press YES to
select maintenance menu.
• Press NO to scroll the list of available routines and then press YES to select Set
torque reference.
• Press YES to update the torque reference data.

BIFFI F01-2000 Specifications

General

Brand	BIFFI
Model	F01-2000
Category	Controller
Language	English