BIFFI F01-2000 - Entering View Mode

September 2021
Installation, Operation and Maintenance Manual
VCIOM-01249-EN Rev. 0
45Local Controls
Section 6: Local Controls
Maintenance
This menu includes all diagnostic and historic data which can help the operator in case
of failure or during maintenance operations. The Maintenance menu also includes the
“Set password” routine.
List of routines:
• Set-up mode
— set new password
— clear alarm log
— set torque prole reference
— set torque curve reference
— clear recent data log
— set maintenance date
— set data logger
• View mode
— alarm log
— torque prole
— torque curve
— operation log
— maintenance date
— data logger
The parameters appear on the alphanumeric display in the same order both in view and
set-up mode. At the end of each routine the program will automatically return to the
beginning of the routine, and the operator can choose to either re-enter (by pressing YES)
or to move on to a next routine (by pressing NO).
6.3 Entering the View Mode
The existing actuator conguration should be checked before commissioning. The
parameters are congured in factory according to a standard setting, or to customer
requirements. In view mode, no password is requested, but no change of parameters can
be made.
• Ensure the electrical main power is applied.
• Move the 3-position selector to OFF and then simultaneously press OPEN/YES
and STOP.
• The display shows the present language. Press YES to conrm or NO to scroll the
list of available languages. Press YES to select a new language. Press YES
to conrm.
• Press NO to scroll the list of available menus (actuator set-up, nameplate, valve
data, maintenance) and then press YES to select the desired menu.
• Press NO to scroll the list of available routines and press YES to select the routine
where the parameter to be changed is located.
• Press NO to scroll the list of parameters and press YES to view the value.