Big Backyard F23210 - Monkey Ladder Assembly

 21 support@cedarsummitplay.com
Step 7: Monkey Ladder Assembly
C: Attach(1858)1-1/8x18-5/8”Doweltobothpostswith2(S2)#8x1-1/2”WoodScrewsperdowel.Onescrew
isinstalledfromtopoftherailsandtheotherfromthebottomasshowning.7.3.

D: Atbottomof(1367)PostMKattach(0353)MKGroundwith2(H12)1/4x3”HexBolts(withlockwasher,at
washerandt-nut).Be sure to keep the bolts loose.(g.7.3)
Note: Pre-drill all holes using a 1/8” drill bit before installing the lag screws.
E: Makesuretheassemblyissquareandthenattach1(0369)LowerDiagonaltoeachendof(0353)MKGround
with1(H2)1/4x2”HexBolt(withlockwasher,atwasherandt-nut)perdiagonal,keepingtheboltsloose,and
toeach(1367)PostMKwith1(LS2)1/4x2-1/2”LagScrew(withatwasher)perdiagonal.Oncelagscrewsare
installedtightenallboltsfromStepsD&E.(g.7.3)
A:Insert1(1858)1-1/8x18-5/8”Dowelinto2(1367)PostMKasshowning.7.1.
B:Makesureshoulderofdowelisagainsteachpostbeforepre-drillingpilot
holes.Drill1/8”pilotholesthroughthepostsandintothedoweltoprevent
splitting.(g.7.2)
Wood Parts
Hardware
2 x 1/4 x 3” Hex Bolt (1/4” lock washer, 1/4” at washer, 1/4” t-nut)
2 x 1/4 x 2” Hex Bolt (1/4” lock washer, 1/4” at washer, 1/4” t-nut)
2 x 1/4 x 2-1/2” Lag Screw (1/4” at washer)
2 x #8 x 1-1/2” Wood Screw
2 x Lower Diagonal 2 x 3 x 37”
1 x MK Ground 1 x 4 x 55-1/4”
2 x Post MK 2 x 3 x 70”
1x Tennon Dowel 1-1/8 x 18-5/8”
0369
S2
0353
1367
1858
LS2
H2
H12
0369
1367
0353
LS2
H2
S2
1367
1858
H2
LS2
1858
1367
Fig. 7.1
Fig. 7.3
1/4”Flat
Washer
1/4”Lock
Washer
1/4”
T-Nut
1/4”Flat
Washer
Fig. 7.2
1858
H12
0369