Binder C 170 E3 - Failure of CO2 Sensor; Error Messages

C (E3) 08/2015 page 52/93
10.10 Failure of CO
2
sensor
If the CO
2
concentration is indicated as “-0.4”, the CO
2
sensor is defective (sensor rupture).
Normalanzeige
Actions:
• Turn off the C 170.
• If necessary, clean, disinfect and sterilize the C 170.
• Please contact BINDER Service.
11. Error messages
While the controller is operating, or when you turn it on or change the operation mode, fault signals may
be emitted that are caused by the controller malfunctioning internally.
Visual display (examples):
LED
Upper display
Lower display
Flashes
Flashes
Flashes
Flashes
Actions:
• Turn the C 170 off with the main power switch.
• Disconnect the power plug.
• Wait for 1 minute.
• Replace the power plug.
• Turn the C 170 on with the main power switch.
• If the fault shows again, the unit could be faulty. Please contact BINDER Service.
Repair must only be performed by qualified service personnel authorized by BINDER.
Repaired units must comply with the BINDER quality standards.