Binder C 170 E3 - Important Conversion Data for Non-SI Units; Conversion Table for Gas Inlet Pressures, Bar - Psi

C (E3) 08/2015 page 81/93
Different electrical data for C 170-UL constructed for the USA and Canada
(model version C170UL-120V-R)
Nominal voltage (±10 %) at 60 Hz power frequency
V
120
Power plug (IEC connector plug)
NEMA
5-20P
Unit fuse
6.3 X 32 mm / 250V / super-time-lag TT / 16A
Further information
Weight (empty)
kg / lbs
110 / 242.5
The recovery times of the gas concentrations inside the chamber following the door being opened coin-
cide with a connection pressure of 2.0 bar / 29 psi. Decreasing supply pressure results in longer recovery
times.
All technical data is specified for unloaded units with standard equipment at an ambient temperature of
+22 °C +/- 3 °C / 71.6 °F ± 5.4 °F and a power supply voltage fluctuation of ±10. The recovery times are
determined in accordance to BINDER Factory Standard Part 1:2015 following DIN 12880:2007. The other
technical data is determined in accordance to BINDER Factory Standard Part 2:2015 and DIN 12880.
All indications are average values, typical for units produced in series. We reserve the right to
change technical specifications at any time.
19.5 Important conversion data for non-SI units
1 ft = 0.305 m = 0.000305 km
1 m = 100 cm = 3.28 ft = 39.37 inch
1 km = 1000 m = 3280.83 ft
1 mbar = 0.0145 psi
19.6 Conversion table for gas inlet pressures, bar – psi
bar
psi
bar
psi
bar
psi
1
14.5
3
43.5
5
72.5
1.5
21.7
3.5
50.7
5.5
79.7
2
29.0
4
58.0
6
87.0
2.5
36.3
4.5
65.2