C (E3) 08/2015 page 9/93
Indications of the type plate
(example)
Nominal voltage ± 10%
at the indicated power frequency
CE conformity marking
Electrical and electronic equipment manufactured / placed on
the market in the EC after 13 August 2005 and to be disposed of
in a separate collection according to directive 2002/96/EC on
waste electrical and electronic equipment (WEEE).
(UL units only)
The equipment is certified by Underwriters Laboratories Inc.
®
according to standards CAN/CSA-C22.2 No. 61010-1, 2
nd
Edi-
tion, 2004-07 (Electrical Equipment for Measurement, Control,
and Laboratory Use; Part 1: General Requirements); UL 61010-
1, 2
nd
Edition, 2005-07-22 (Electrical Equipment for Measure-
ment, Control, and Laboratory Use; Part 1: General Require-
ments); IEC 61010-1:2001, 2
nd
Edition and IEC 61010-2-10 (Par-
ticular Requirements for Laboratory Equipment for the heating of
materials).
1.5 General safety instructions on installing and operating the CO
2
incubator
With regard to operating the CO
2
incubator C 170 and to the installation location, please observe the
guideline BGI/GUV-I 850-0 on safe working in laboratories (formerly BGR/GUV-R 120 or ZH 1/119 la-
boratory guidelines issued by the employers’ liability insurance association) (for Germany).
BINDER GmbH is only responsible for the safety features of the unit provided skilled electricians or quali-
fied personnel authorized by BINDER perform all maintenance and repair, and if components relating to
chamber safety are replaced in the event of failure with original spare parts.
To operate the unit, use only original BINDER accessories or accessories from third-party suppliers au-
thorized by BINDER. The user is responsible for any risk caused by using unauthorized accessories.
CAUTION
Danger of overheating.
Damage to the unit.
∅ Do NOT install the unit in unventilated recesses.
Ensure sufficient ventilation for dispersal of the heat.
Do not operate the CO
2
incubator C 170 in hazardous locations.
DANGER
Explosion hazard.
Danger of death.
∅ Do NOT operate the unit in potentially explosive areas.
∅ KEEP explosive dust or air-solvent mixtures AWAY from the unit.
To Next Page
Loading...
