Biosite Triage MeterPro - How to Set Parameters: Basic Instructions; C Haracters U Ser ID Min; Meter Settings

N-11Rev F
InStallatIon
N-11
How to Set Parameters: Basic Instructions
All instructions assume:
 • Themeterison.
 • Themeterscreenisdisplayingthemainmenu.
 • TheSupervisorCodeChipmoduleisinstalled.
1. Select Set parameterS using the keys.
2. Press the key.
3. You will see a list of programmable parameters.
4. Use the keys to select the parameter you want to program:
meter SettIngS, clock, uSer Id, rangeS, teSt SettIngS, Qc parameterS,
or BypaSS.
5. Press the key.
6. Follow the directions for setting the selected parameter (see the next section).
meter SettIngS
This menu will allow you to set basic operational criteria for the meter: language, display
contrast, maximum length of the user, patient, auxiliary and misc. ID’s, printer mode and
automatic power off.
Id SettIngS
characterS uSer Id
This setting will set the minimum and maximum number of characters in the User ID.
1. From a list of programmable parameters, choose InStrument SettIngS
using the keys.
2. Press the key.
3. Use the keys to select Id SettIngS.
4. Press the key.
maIn menu
Set parameterS
meter SettIngS
Id SettIngS
Note: To save
changes, press
the ENTER key.
To cancel changes,
press the EXIT key.
When either the
ENTER or EXIT keys
are pressed, the
meter performs the
appropriate function
and returns to the
previous menu.
The Set Parameters Menu