Biosite Triage MeterPro - Operation; Access to Meter Functions

O-1 Rev F
operatIon
Access to The Triage MeterPro Meter
Function Use Restricted to
run teSt Patient Testing Operators with valid User ID’s*
Quality Control Testing Operators with valid User ID’s*
Misc. Test Testing Operators with valid User ID’s*
recall reSultS Last Record If last test run is a patient sample:
Operators with valid User ID’s*
Otherwise: No restriction
Patient Test Results Operators with valid User ID’s*
Quality Control Results
Misc. Test Results
InStall code chIpS Types of Code Chips
Installation Procedure
Set parameterS Access Control Supervisor
Programmable Settings Supervisor
delete reSultS Patient Test Results Supervisor
* Unless User ID is bypassed or the Supervisor Code Chip module is installed.
Important: The last two functions, Set parameterS, and delete reSultS, appear on
the main menu only when the Supervisor Code Chip module is inserted into the
Code Chip module Port. The Supervisor Code Chip module should be removed from
the meter during routine patient, quality control, and Misc. testing.
Operation
Note:Accessto
various parts of
the software is user
(institution) defined.