Biosite Triage MeterPro - Recalling Test Results

O-10Rev F
operatIon
Recall Results
O-10
Purpose
Recall Results is used to retrieve results stored in the Triage MeterPro Meter’s memory.
Function
The Recall Results function can retrieve these results:
• LastRecord • QCResults
• PatientResults – QC Sample Results
– Patient ID – QC Device Results
– Panel Type – Reagent Lots – QC
– Test Device Lot Number (L/N) – Archive Last Test
– User ID • Misc.TestResults
– From Date • PrintallResults
– Till Date – Patient Results
– QC Sample Results
– QC Device Results
– Misc. Test Results
• UploadResultstoLIS
Important note: To safeguard the User ID Lockout, displayed and printed
User ID are partially masked. The Supervisor Code Chip module is required to be
installed to view the full User ID.
laSt record
Purpose: Last Record is used to retrieve the test results for the last test run.
To retrieve the last record:
1. Press the key to power The Triage MeterPro Meter on.
2. From the maIn menu select recall reSultS using the keys.
3. Press the key.
4. Select laSt record using the keys.
5. Press the key.
6. If the last test run is a patient result, type or scan in your identification (User ID). To
correct, press to clear the entire ID, or select the incorrect character by using
the keys. Then type in the correct ID.
7. Press the key.
Note: If a result
was rejected by
the user, an “R”
willappearnexttothe
recalled result.
maIn menu
recall reSultS
Note: If the
User ID bypass
is ON, the meter will
not ask you to enter a
User ID.