N-10 Rev F
InStallatIon
Set Parameters
N-10
Code Chip module
Code Chip module Port
Purpose
The Set parameterS function allows the supervisor to select a number of settings.
Access to these settings is controlled using the Supervisor Code Chip module.
List of Programmable Parameters
A supervisor can set the following parameters:
Heading Parameters
meter SettIngS
Id SettIngS Number of Characters in User ID, Number of Characters
in Patient ID, Number of Characters in Auxiliary ID,
Enable or Disable Auxiliary ID, Number of Characters in Misc
Test ID
dISplay SettIngS Language, Printer Mode, Auto Power-Off, Display Contrast,
Printer Contrast
communIcatIonS Baud Rate, Enable or Disable LIS, Enable or Disable Auto
Upload, Enable or Disable Patient Result Approval
clock Time, Date, and Display Format
uSer Id Add New User ID, Update User ID, Delete User ID
or User ID List
rangeS Test Cutoffs
teSt SettIngS Block Analytes
Qc parameterS Minimum Frequency for QC Tests, Number of Controls,
Number of Standard Deviation (Quantitative Tests)
BypaSS Disable User ID requirement
Supervisor Access
A Supervisor Code Chip module is shipped with each meter. Installing the Code Chip
module gives the supervisor access to the Set parameterS and delete reSultS function.
To insert the Supervisor Code Chip module into the Triage MeterPro Meter, slide the chip
labeled “SPR” into the meter’s Code Chip module port as shown in the picture.
To Next Page
Loading...