Biosite Triage MeterPro - Page 77

O-34Rev F
operatIon
O-34
delete patIent reSult
This function will delete all patient results in meter memory. Since this action is not
reversible, the meter will require two confirmations of intent to delete results.
1. Insert the Supervisor Code Chip module in the Code Chip module Port.
Code Chip module
Code Chip module Port
2. From the maIn menu, select delete reSultS using the keys.
The Supervisor’s Main Menu
3. Press the key.
4. A warning message on the screen states: delete patIent reSult.
5. If this is acceptable, press the key. (If this is not acceptable, press
the key).
6. A message on the screen states: all patIent reSultS wIll Be deleted.
7. Press the key to delete all patient results. (If you do not want to delete all
patient results, press the key).
maIn menu
delete reSultS
Note: Press
the EXIT key
to cancel at any time
before step 7.