Maintenance Instruction manual A400 / A400FB
8 - 4 6.054.98.5.10.06 en
8
Fig. 40: Remove conveyor belt
Use both hands to hold on to the sides
of the center of the conveyor belt and tilt
it towards you and then lift it up.
Place the belt carefully on to an even
surface.
Damaged or twisted wire meshing can
cause operational malfunctions.
Depositing arm
Fig. 41: Depositing arm
Loosen three-square knob and pull the
hub of the depositing arm out of the
bearing to the left.
Chain frame
Fig. 42: Chain frame
Using the right hand turn the feed roller
to the left and hold it firmly.
Using the left hand lift the complete
chain frame out of the bearing in the up-
ward direction.
Put chain frame aside with rear side
downward.
To Next Page
Loading...
Need help?
General
