Labeling Inputs and Outputs
The ‘inputs’ and ‘outputs’ tab lets you change the labels for all your source inputs and
destination outputs.
To label a source and output:
1 Click in a source or destination’s text field.
2 Type a new name. Press the return key on your computer keyboard to move to the next
field, or simply click in the next text field to select it.
3 When you have entered all the labels, click ‘save’.
It’s important to label them so they match the shortcut button labels on the unit, for example
DECK for playback and recording decks, MON for monitor destinations, etc. If you want
to change them to something else, you should also change the physical shortcut button
labels on the unit to make sure they correspond. You can find information on how to change
thepushbutton labels in the ‘labeling pushbuttons’ section.
TIP Videohub text filtering is case sensitive.
Once you have labeled your source inputs and destination outputs, you can also save them
as a label set. This means if you need to change the labels for a new project, you can always
reload the previous set you saved earlier.
To save a label set:
1 Click on the gear icon at the bottom of the inputs or outputs settings and select ‘save
label set’.
2 Type a name for the label set and choose the save location. Click ‘save’.
To load a label set:
1 Click on the gear icon at the bottom of the inputs or outputs settings and select ‘load
label set’.
2 Choose the label set you have previously saved and click ‘open’.
47Blackmagic Videohub Setup
To Next Page
Loading...
