EasyManuals Logo

Blodgett ZEPHAIRE-G Installation And Operation

Blodgett ZEPHAIRE-G
53 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
Maintenance
24
Troubleshooting Guide
POSSIBLE CAUSE(S) SUGGESTED REMEDY
SYMPTOM: Oven will not fire.
S Gas turned off.
S Oven not plugged in.
S Power switch on the control panel is off.
S Control set below ambient temperature.
S Doors are open.
S Turn the gas valve to ON.
S Plug in electrical supply cord.
S Set the control panel to COOK or O VEN ON.
S Set to desired cook temperature.
S Close doors.
SYMPTOM: Oven does not come to ready.
S The ovenhas not reached preheat temperature.
S Gas valve not turned on completely.
S The quick disconnect is not connected.
S Gas pressure to oven is too low.
S Internal problem with main temperature control.
S Wait for oven to reach preheat temperature.
S Check the gas valve, turn on fully if necessary.
S Reconnect the quick connect. Check all gas
connections.
S Call your local gas representative.
S *
SYMPTOM: Convection fan does not run.
S Oven is not plugged in.
S Circuit breaker tripped.
S Doors are open
S Plug in electrical supply cord.
S Reset the breaker.
S Close doors.
SYMPTOM: General baking problems.
S Thermostat out of calibration.
S Improper oven venting.
S *
S *
*Denotes remedy is a difficult operation and should be performed by qualified personnel only. It is recommended, however, that
Allrepairs and/or adjustments be done by your localBlodgettservice agency and not by the owner/operator. Blodgett cannot as-
sume responsibility for damage as a result of servicing done by unqualified personnel.
WARNING!!
Always disconnect the power supply b efore cleaning or servicing the oven.

Other manuals for Blodgett ZEPHAIRE-G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Blodgett ZEPHAIRE-G and is the answer not in the manual?

Blodgett ZEPHAIRE-G Specifications

General IconGeneral
Pan Size18" x 26"
Temperature Range200°F to 500°F
ControlsSolid State
ConfigurationSingle Deck
ConstructionStainless steel front, top, and sides
Warranty1 year parts and labor

Related product manuals