105
Údržba stroje
Wartung
4.9.5. Driving wheel replacement
30. Dismantle the saw band.
31. Screw of the fastening screw of the driving wheel and pull off the washer.
32. Screw on the auxiliary screw to the driving shaft.
33. Install the three-leg puller on the driving wheel and pull off it from the shaft.
34. Check, if the spring and the driving shaft are not damaged. Contact your
supplier for parts replacement.
35. If the shaft and the feather are in good order, clean them, oil them and install
them on the driving shaft.
To Next Page
Loading...
Need help?
General