17
Bezpečnostní pokyny
Sicherheitshinweise
Do not remove the chips from the working area of the machine, when the
machine is running!
Do not use compressed air for machine cleaning or for chip removal!
Use protective gear for chip removal!!
1.4. Safety notes for the servicing and repairs
Switch off the main switch and lock it, before you start service work! If you have the
Practix type of machine, disconnect it from electrical network. This way you
eliminate a possibility of starting the machine accidentally.
Take care when manipulating the frequency converter. It is still energized for 20
minutes after machine shutdown.
Always adhere to the safety instructions!
Only an authorized professional can carry out the servicing and repairs.
For parts replacement, use only those, which are identical with the originals.
Otherwise, there is possibility of health hazard.
Use only recommended types of hydraulic oils, oils and lubricants!
Do not remove or lock the limit switches or any other safety equipment!
Any use of the saw, accessories or machine parts other than that intended by
BOMAR, spol. s r.o. company is not permitted. The guarantee on this product will
be lost afterward and BOMAR, spol. s r.o. takes no responsibility for damage
caused.
Do not turn the machine on if all covers are not in place.
.
1.4.1. Safety notes for the servicing and repairs on hydraulic unit
Compliance with the principles of cleanness is a basic requirement for trouble-free
operation of hydraulic equipment. Hydraulic components are products made with
high precision, and any contamination leads to a reduction of lifetime and even
malfunction. The consequences are very difficult and expensive to remove.
Always use clean tools. Never put parts and fasteners which are a part of the
hydraulic circuit on a dirty surface. The best cleaning agent is crepe paper. The
fibers of the cleaning cloths can also cause malfunction.
Remove the protective caps from the threaded chamber just before the assembly
of the unit.
Flush hoses and pipes before mounting with gasoline or other cleaning agent and
blow compressed air through them.
All fittings must be properly tightened. However, do not use brute strength.
Attention!
Only a qualified professional can carry out the servicing
and repairs of the electrical equipment! Take special care
during the work with electrical equipment. High voltage
shock can have fatal consequences! Always follow the work
safety instructions! Otherwise, there is possibility of heavy
injury!
To Next Page
Loading...
Need help?
General