89
Údržba stroje
Wartung
5. Setting the air quantity using another regulator - arrow 6
6. Switching on / off of the Microniser is depends on the control system of the
machine it is installed on. See chapter “Machine control”.
Recommended cutting oils for Micronisation:
Manufacturer Cutting oil
Biona Biocut
Paramo Paramo cut 22
Featured are cutting oils with viscosity class 22.l
Adding of the coolant is possible after removing the filling cap. After the filing is
finished the cap must be screwed in again.
Package Includes: a tank with regulators, connection 6m hose, diffuser.
4.5.4. Chips disposal
Chips resulting from cutting operations must be disposed of in accordance with the
relevant regulations.
Let the chips drip excess fluid!
Put the chips into a watertight container. Make sure that the container does
not leak, because even after a long dripping time, the chips still contain
coolant residues.
Place the container into the care of a disposal company equipped for the
disposal of chips contaminated with cooling liquid. In case the machine is
equipped with micronisation device, the chips must also be handed over to a
disposal company.
To Next Page
Loading...
Need help?
General