18
Manual version: 1.01/ Febr. 2017
Manual rev.: 1
Bezpečnostní pokyny
Sicherheitshinweise
1.5. Safety notes for the cooling
1.5.1. Instructions for first aid
1. Pull off and safely remove polluted, soaked clothing.
2. If inhaled, go out on fresh air or look for first aid treatment.
3. Wash with water and eventually treat with crème any points of contact with the
skin.
4. Flush your eyes with water and seek out a doctor.
5. If swallowed, drink a lot of water and induce vomiting. Look for medical help
1.6. Safety machine accessories
The machine is equipped with safety accessories. They protect the operator from
injuries and the machine from damage. The safety accessories are blocking
accessories, emergency switches and covers. Check the function of the safety
accessories once a week. If the safety accessories are not fulfilling their function,
stop your work and repair or change the safety accessories.
1.6.1. Total Stop
TOTAL STOP button is used for emergency switching – off of the machine in a case
of defect or health hazard. By pressing TOTAL STOP will immediately stop all
dangerous machine movements..
If any damages or fault appear, immediately press the TOTAL STOP button!
Release of the pressed button is possible by turning the upper part of the button.
Enhanced risk!
Do not come into or intervene in the cutting area.
Otherwise, there is a possibility of heavy injury.
Attention!
When handling the coolant always keep to the work
safety directives and instructions of the manufacturer.
When handling cooling agents always wear safety
fluid-proof gloves!
Wear protective goggles!
Cooling liquid can get in contact with your eyes and
may cause permanent severe injuries
To Next Page
Loading...
Need help?
General