61
Ovládání stroje
Bedienung der Maschine
3.3.7. Setting the type of cooling
The required type of cooling can be chosen using knob no. 3 o the control panel.
Cooling with liquid:
1. The cooling pump runs, even if the pump is turned off (washing)
2. The saw band runs without cooling.
3. The cooling is turned on together with the saw band drive
Cooling with oil vapor- Microniser (optional equipment)
4. Saw band runs without cooling.
5. Cooling is turned on together with the saw band drive.
3.3.8. Pressure adjusting to the cut
The band saw is equipped with automatic down-feed regulator on the right guiding
cube. The band saw can be equipped with down-feed regulator on the left guiding
cube for requirement of the customer.
To Next Page
Loading...
Need help?
General