To Next Page

To Previous Page

Manual version: 1.01/ Febr. 2017

Manual rev.: 1

Údržba stroje

Wartung /

Machine service

4.5.2. Cooling liquid preparation

Prepare a mixture of water and cooling liquid. Conform the notes of the

manufacturer and keep the manufacturer’s-approved concentration

All instructions are stated on the tank of the cooling liquid or in documentation of

the cooling liquid. For cooling liquid usage and disposal heed the instructions of the

manufacturer.

Fill the mixture of water and cooling liquid to the tank of the cooling system

When filling the tank with the cooling liquid take care that the liquid will not drip

out of the tank and the tank does not overflow

Keep to the manufacturer specified recommendations for adding the anticorrosive

agents, the antifreeze or other agents! Mixing two chemicals can produce toxic and

aggressive substances, which can damage your health or the cooling system of the

machine

Note: If the machine is equipped with Microniser (see. Special accessory), fill the

tank of the Microniser with specified cooling liquid. Then the microniser is ready for

the operation

The quality of the cooling agent will deteriorate due to:

 use of contaminated water

 impurities

 outside oil contamination (hydraulics, gears)

 high operating temperatures

 lack of air circulation

 wrong concentration

If the solution is too weak:

 corrosion protection is diminished

 lubrication decreases

 microbial attack is more likely

If the solution is too strong:

 the cooling ability is decreased

 foam behavior increases

 emulsions stability deteriorates

 sticky residue develops

Bomar Ergonomic Series User Manual

Questions and Answers: