76
Manual version: 1.01/ Febr. 2017
Manual rev.: 1
Údržba stroje
Wartung /
4.3.1. Saw band stretching
8. After installation of the saw band stretch it gently, so it does not fall of the
wheels.
9. Mount the Tenzomat on the saw band and secure it with screws.
10. Stretch the saw band until it is stretched to the recommended value.
For a quick control of the tension of the band there is an indicator near the
tightening star. If the indicator agrees with the picture bellow, the band is stretched
correctly.
4.3.2. Saw band inspection
If the band does not run correctly, following problems can appear:
The band falls down from the wheels – the band or the protective cover of
the band can be damaged.
The band runs on the rim of the stretching wheel – the band or the rim of
the wheel can be damaged.
11. Switch on briefly the saw band drive and then switch it off
12. Disconnect the saw from the electrical network.
13. Open cover of the wheels and check the position of the saw band on the both
wheels.
To Next Page
Loading...
Need help?
General