43
Dokumentace stroje
Dokumentation der Maschine
Open and close the main vice. Turn the saw frame of the band saw from one outer
position to the other outer position. Raise the saw frame to the top position and
than lower the saw frame to the lowest position.
Start the machine with the cooling pump and let it run without load until the
cooling system will be filled with cooling liquid. As soon as the cooling liquid starts
to escape from the nozzles of the cooling system, the cooling system is ready for
operation. Carry one cycle of cutting without material. Check, if the machine runs
with no irregularities. If all machine functions are run properly, the machine is ready
for operation.
To Next Page
Loading...
Need help?
General