Bosch B9512G - Page 6

6 en | Table of contents Control Panels
2018.07 | 10 | F.01U.303.996 Installation Manual Bosch Security Systems, Inc.
14.2 B820 SDI2 Inovonics Interface Module 86
14.2.1 SDI2 address settings 86
14.2.2 Supervision 86
14.2.3 Installation and control panel wiring (B820) 86
15
Access control 88
15.1 B901 door controller 88
15.1.1 Address settings 88
15.1.2 Supervision 88
15.1.3 Installation and control panel wiring (B901) 89
15.2 D9210C access control interface module 89
15.3 Card reader wiring 90
16
Program and test the control panel 91
16.1 Program the control panel 91
16.1.1 Program the control panel with RPS 91
16.1.2 Program the control panel with the Installer Services Portal programming tool 92
16.1.3 Program the control panel with a keypad 92
16.2 Walk tests 92
16.2.1 Fire walk test 92
16.2.2 Intrusion walk test 93
16.2.3 Service walk test 93
16.2.4 Invisible walk test 94
17
Control panel board overview 95
18
System wiring diagrams 97
18.1 Power supply side wiring 98
18.2 Input points wiring with D125B, D130, or D129 99
18.3 Input points wiring with or without EOL resistors 99
18.4 SDI and ZONEX wiring 100
18.5 SDI2 devices general system wiring 102
18.5.1 SDI2 bus wiring recommendations 102
18.6 2-wire smoke wiring (D125B) 104
19
Approved applications 106
19.1 Optional compatible equipment 106
19.1.1 Burglar applications 106
19.1.2 Bank safe and vault applications 106
19.1.3 Fire applications 109
19.1.4 Enclosures 111
19.2 Combination fire and intrusion alarm systems 111
19.3 Compatible UL listed components 111
19.4 Standby battery requirements and calculations 114
19.4.1 Household Fire Warning equipment 117
19.5 UL 365 - Police Station Connected Burglar Alarm Units and Systems 118
19.6 UL 636 - Holdup Alarm Units and System 118
19.7 Required programming to meet UL 864 118
19.8 Required values to achieve 180s (ULC)/200s (UL) supervision interval 122
19.9 ULC 122
20
Keypad Installer menu 123
20.1 [1] Program menu (Programming) 130
20.1.1 [1] Reporting > [1] Phone menu parameters 130
20.1.2 [1] Reporting > [2] Network menu parameters 131