Bosch DS7240-UK - User Tamper Options; User Tamper Retry Count

DS7240-UK Reference Guide Copyright  2003 Bosch Security Systems P/N: 4998122677Cr1 Page 73
PART III: PANEL PROGRAMMING
31.2 User Tamper Options
• Address: 0380
• Default: 0 (No User Tamper Options)
• Selections: 0-3
Enter This Data Digit to Select Options
User Tamper Options 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
No User Tamper Options
••
User Tamper [156] Reports Enabled
•• ••
User Tamper Activates Burg Alarm Output
•• ••
Reserved
Reserved
Default
31.2.1 Parameter Description
A user tamper event is:
• A user entering a PIN that is not in the system (the user must enter the invalid PIN the number of times shown in Section
31.3 User Tamper Retry Count).
• A user entering a PIN that is in the system but does not have the authority for the desired function.
31.2.2 Parameter Options
• User Tamper Reports Enabled: User Tamper events appear at all keypads assigned to the area where the user is
accessing the system. User Tamper [156] reports and user tamper activated alarm outputs are tied to the keypad’s area. If
only the User Tamper [156] Reports Enabled option is selected and there is a user tamper event, the text keypad where the
event occurs shows “Keypad Locked!”
• User Tamper Activates Burg Alarm Output: If the burglary alarm output (steady alarm output) is selected and there is a
user tamper event, the text keypad where the user tamper occurred shows “Keypad Locked!” Other text keypads in the area
show “Usr Tamper Alarm, Enter PIN to silence.” While the keypad is locked out, any key pressed produces an error tone (for
text and LED keypads). Selecting “User Tamper Activates Burg Alarm Output” specifically activates output functions 1-8, 1-9
and 1-10. See Table 27, “Output Function Types,” on page 112, for descriptions of these output functions.
31.3 User Tamper Retry Count
• Address: 0381
• Default: 4 (4 attempts)
• Selections:
• 0 = User Retry Count Disabled
• 1-15 = Number of attempts allowed before a User Tamper event occurs
31.3.1 Parameter Description
Entering zero (0) disables this feature. The panel creates a User Tamper event when a user enters an invalid PIN the number
of times programmed in this parameter.
For example, “5” is entered in this parameter. When an invalid PIN is entered five times, a User Tamper event occurs.