Bosch DS7240-UK - PIN, User

Page 76 P/N: 4998122677Cr1 Copyright  2003 Bosch Security Systems DS7240-UK Reference Guide
PART III: PANEL PROGRAMMING
Personal Identification Number (PIN) Addresses Authority
Level
Area
User # Digit 1 Digit 2 Digit 3 Digit 4 Digit 5 Digit 6 Digit 7 Selection Selection
28
Addr 0633
(0)
Addr 0634
(0)
Addr 0635
(0)
Addr 0636
(0)
Addr 0637
(0)
Addr 0638
(0)
Addr 0639
(0)
Addr 0640
(0)
Addr 0641
(0)
29
Addr 0642
(0)
Addr 0643
(0)
Addr 0644
(0)
Addr 0645
(0)
Addr 0646
(0)
Addr 0647
(0)
Addr 0648
(0)
Addr 0641
(0)
Addr 0642
(0)
30
Addr 0651
(0)
Addr 0652
(0)
Addr 0653
(0)
Addr 0654
(0)
Addr 0655
(0)
Addr 0656
(0)
Addr 0657
(0)
Addr 0658
(0)
Addr 0659
(0)
31
Addr 0660
(0)
Addr 0661
(0)
Addr 0662
(0)
Addr 0663
(0)
Addr 0664
(0)
Addr 0665
(0)
Addr 0666
(0)
Addr 0667
(0)
Addr 0668
(0)
32
Addr 0669
(0)
Addr 0670
(0)
Addr 0671
(0)
Addr 0672
(0)
Addr 0673
(0)
Addr 0674
(0)
Addr 0675
(0)
Addr 0676
(0)
Addr 0677
(0)
Table 16: User Configuration Addresses & Defaults (cont.)
User 28 is the Guard Code User. See Section 34.8 Guard Code Options on page 85 for more information.
User 32 is the default Duress User. See Section 34.5 Duress Reporting Options on page 83 for more information.
32.1 PIN, User #
• Address: See Table 16
• Default: See Table 16
• Selections: 0-9
32.1.1 Parameter Description
Use the PIN parameter to enter a PIN for each user. The PIN length parameter determines the number of digits in the PINs.
The default PIN for User 1 is 1234. The default Installer PIN is 7890.
• If the PIN length is increased to five digits, the default User 1 PIN becomes 12340; the default Installer PIN becomes 78900
• If six digits are selected, the default User 1 PIN becomes 123400; the default Installer PIN becomes 789000
• If seven digits are selected (maximum number), the default User 1 PIN becomes 1234000; the default Installer PIN becomes
7890000
Do not use digits 10-15 when creating a User PIN. Entering these digits makes the PIN unusable and locks the
user out of the panel.
If the User 1 PIN is left at its factory default, the panel generates a System Trouble event as set in the Date
Format and Enable PIN Trouble parameter (see page 44). Make sure to change the default value. This event is
Local Only and is stored in the history buffer.
The Date Format and Enable PIN Trouble feature is disabled by default.