FPD-7024 | Operation and Installation Guide | 4.0 Programming
.
Bosch Security Systems, Inc. | 1/10 | F01U008458-03
33
4.2 Point Programming
Each of the points in the system can be
programmed with its own characteristics. Point
functions simplify the programming of points by
allowing you to define a common set of
characteristics for similar points, and assigning
those characteristics to selected points as a point
function. There are 16 point functions, each of
which has programmable features for configuration
(fire, waterflow, and so on), local only operation,
silencing, and loop response. Each point is
assigned to use the characteristics of one point
function (Table 16), and then is individually
programmed for additional characteristics:
response to an open circuit, enabled status, output
zone, verification, latching and point description.
Before programming the control panel, determine
the types of functions that are needed, and then
map the various input points to the functions.
For example, you might determine that you have
the following functions:
Refer to Table 16 for the characteristics that
correlate with each function.
• 1 = Pull Station
• 2 = Smoke Detector
• 3 = Reset Keyswitch
• 4 = Silence Keyswitch
• 5 = Supervisory Input
• 6 = Local Test
• 7 = Waterflow Sensor
Refer to Appendix D on page 93 for
default point function information.
Table 16: Point Function Characteristics
Function Configuration Local Only? Silenceable? Loop Response
1. Pull Station Fire No No Fast
2. Smoke Detector Fire No No Fast
3. Reset Keyswitch Reset Yes No Fast
4. Silence Keyswitch Silence Yes No Fast
5. Supervisory Input Supervisory No Yes Fast
6. Local Test Fire Yes Yes Fast
7. Waterflow Sensor Waterflow No No Programmed
To Next Page
Loading...
